Aavolyn is a Manufacturer and Supplier of
High Quality Compressor Replacement Parts
All Categories > Rod and Wiper Packing > Cast Iron TY313 Wiper Rings > View Items  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Cast Iron TY313 Wiper Rings

 
Check up to five results to perform an action.

This AAVOLYN Type 313 oil wiper ring is used in reciprocating compressors to prevent oil from the crankcase traveling along the piston rod and into the pressure packing. It consists of an individual oil seal manufactured tangent to the rod with no clearance at the bore. Each ring is an independent seal with a deep wiping edge and wide oil groove at the I.D. The oil groove acts as a second wiping edge and uses drilled holes to allow the wiped oil to drain away from the rod. AAVOLYN uses a tapered wiping edge on the face of the ring to more effectively strip the oil coating from the piston rod.



   
  Results 1 - 25 of 66 1 2 3 

Aavolyn #

Cylinder/ Rod Diameter

Material
20011-31363-028 3.750 Cast Iron
30011-31343-012 2.000 Cast Iron
11-31363-006 1.375 Cast Iron
11-31363-007 1.500 Cast Iron
11-31363-008 1.562 Cast Iron
11-31363-009 1.625 Cast Iron
11-31363-010 1.750 Cast Iron
11-31363-012 2.000 Cast Iron
11-31363-013 2.125 Cast Iron
11-31363-014 2.250 Cast Iron
11-31363-017 2.500 Cast Iron
11-31363-019 2.750 Cast Iron
11-31363-022 3.000 Cast Iron
11-31363-024 3.250 Cast Iron
11-31363-025 3.375 Cast Iron
11-31363-026 3.500 Cast Iron
11-31363-030 4.000 Cast Iron
11-31361-005 1.250 Cast Iron
11-31313-010 1.750 Cast Iron
30011-31363-024 3.250 Cast Iron
30011-31363-019 2.750 Cast Iron
30011-31363-026 3.500 Cast Iron
30011-31363-030 4.000 Cast Iron
30011-31363-006 1.375 Cast Iron
20011-31123-024 3.250 Cast Iron
  Results 1 - 25 of 66 1 2 3