Aavolyn is a Manufacturer and Supplier of
High Quality Compressor Replacement Parts
All Categories > Rod and Wiper Packing > AVA45 TY211 Packing Rings > Aavolyn # 03053-21101-010  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Aavolyn # 03053-21101-010, AVA45 TY211 Packing Ring Set


The Type 211 pair of packing rings consist of two tangent to the step rings pinned together to overlap at the step. This design has traditionally been used to seal low pressure or vacuum applications. The pair of tangent rings allows the 211 style to seal in both directions. Because of the large sealing surface, more frictional heat is generated and therefore greater wear to the piston rod and the seal itself. The 211 design does not allow gas to pass back through the packing case when pressure drops from discharge to suction in the cylinder, therefore its application should be limited to low pressures such as after the vent connection, vacuum service or in partition packings.





Specifications

Cylinder/ Rod Diameter
1.750

Material
AVA45

Quantity
3

Material Description
AVA45 performs exceptionally well in non-lubricated applications where operating temperatures are a major factor in the performance of the seal. AVA45 combines the strength and thermal conductivity of the bronze with the frictional properties of the Moly Disulfide for both cryogenic and high temperature air service. Wear tests performed by the US Navy for their high pressure non lube compressors showed AVA45 to have the best wear properties of all standard PTFE tested.
Recommended Applications: High Temperature Air Cryogenic Service