Aavolyn is a Manufacturer and Supplier of
High Quality Compressor Replacement Parts
All Categories > Rod and Wiper Packing > AVA47 TY211 Packing Rings > View Items  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

AVA47 TY211 Packing Rings

Check up to five results to perform an action.

The Type 211 pair of packing rings consist of two tangent to the step rings pinned together to overlap at the step. This design has traditionally been used to seal low pressure or vacuum applications. The pair of tangent rings allows the 211 style to seal in both directions. Because of the large sealing surface, more frictional heat is generated and therefore greater wear to the piston rod and the seal itself. The 211 design does not allow gas to pass back through the packing case when pressure drops from discharge to suction in the cylinder, therefore its application should be limited to low pressures such as after the vent connection, vacuum service or in partition packings.



   
  Results 1 - 25 of 37 1 2 

Aavolyn #

Cylinder/ Rod Diameter

Material

60-21121-010 1.750 AVA47
60-21152-014 2.250 AVA47
02060-21102-017 2.500 AVA47
02060-21102-024 3.250 AVA47
02060-21102-030 4.000 AVA47
02055-21101-014 2.250 AVA47
03060-21102-017 2.500 AVA47
03060-21102-024 3.250 AVA47
04060-21121-007 1.500 AVA47
60-2112X-002 0.875 AVA47
60-21123-014 2.250 AVA47
60-21120-004 1.125 AVA47
60-21121-007 1.500 AVA47
60-21122-017 2.500 AVA47
60-21102-024 3.250 AVA47
60-21153-014 2.250 AVA47
04060-21102-017 2.500 AVA47
60-21101-013 2.125 AVA47
60-21101-014 2.250 AVA47
60-21102-017 2.500 AVA47
60-21102-026 3.500 AVA47
60-21102-030 4.000 AVA47
60-21103-024 3.250 AVA47
60-21104-035 5.250 AVA47
60-21121-012 2.000 AVA47
  Results 1 - 25 of 37 1 2